JuiceGoose iP 1 (Piwi) - Manual (Page 5)

DETAILED INSTALLATION AND SETUP
Unbox the unit. The box contains: the iP-1 unit, a 3 gang electrical box, the iP-1
manual and a warranty card .
Have the 3 gang box supplied with the iP-1 (or an acceptable alternative), in-
stalled by a qualified electrician along with the iP-1. The wire harness from the
IP-1 will be located within the empty portion of the 3 gang box and connected to
the mains power supply using wire nuts.
A CAT5 network cable within wall will also be needed and should be connected
to the RJ45 input on the iP-1 which is accessible from the outside of the 3 gang
box.
Complete wire and network cable installation and mount the iP-1 securely be-
fore turning on power to the unit at the circuit breaker panel.
SET UP DETAIL
Connecting to the iP-1 to a router. (Singular units)
1. After installation of the iP-1 connect the free end of the RJ45 cable into your
router.
2. The iP-1 will take a few seconds to boot up and configure itself once it re-
ceives power, at which point the Network light on the front of the unit should
illuminate and remain on without blinking, indicating network connectivity. If the
Network light blinks check the cable connections.
3. Open a web browser on a PC connected to the same network router as the
iP-1 and type in the following address on the navigation bar to access the iP-1:
http://juicegoose
Be sure to type exactly as shown. No domain such as .com should be
added.
4. You will be presented with the login box. Enter the following initial username
and password (these can be changed later):
User: admin
Password: juicegoose
Setting up multiple iP-1’s.
DHCP is automatically enabled on the iP-1 out of the box, as such plugging
multiple units into a router without first assigning the Individual IP addresses
may cause problems identifying each units actual IP address.
If you are setting up multiple iP-1s on the same network a different setup ap-
proach is advised, which can be accomplished in 2 ways.
Page 4