King Electric F802GFCI Electronic Programmable - Manual (Page 3)

3
SAVE THESE INSTRUCTIONS
GENERAL INFORMATION
F802GFCI
Thermostat
DANGER
! !
ELECTRIC SHOCK OR FIRE HAZARD
READ ALL WIRE SIZING, VOLTAGE REQUIREMENTS AND
SAFETY DATA TO AVOID PROPERTY DAMAGE AND
KING ELECTRIC MFG CO · 9131 10TH AVENUE SOUTH · SEATTLE, WA 98108 · PH:206 762 0400 · FAX: 206 763 7738 · www.king-electric.com
Initial Setup :
Note: Unit must have the On/Standby switch in the On position
to program. In Standby mode the buttons will not work and no
power will go to the heater.
When you first apply power if the day and time appear but OFF
does not display on the unit, hold Day/Time button until hour
blinks and set local time. The other buttons will not work until
time is set.
Setting Local Day and Time ,
Hold the Day/Time button until the hour blinks and use the ▼
and ▲ to adjust time. Press Day/Time to go to minute and
adjust using ▼ and ▲. Press again to adjust day, press once
more or wait 16 seconds to save settings.
SETTING THERMOSTAT OPTIONS
Hold the Options button to access options. Press the Options
button again to cycle through the various options. Pressing Hold/
Return, or Options, or waiting 16 seconds will save you settings.
Fahrenheit/Celsius Options
This thermostat has both °F/12 hr and °C/24 hr formats. Hold
Options until °F/12 hr or °C/24 hr appears and press ▼ and ▲
to switch between them.
Sensor and Timer Mode Options
This thermostat has three temperature control modes.
1: Room and Floor Temperature Sensor Mode (Sens/Air) senses
the ambient air temperature and the floor temperature to
regulate temperature. To select hold Options until you get the
options menu, press Options until Sens or Regu appear. Press
the ▼ and ▲ to select Sens/Air press Hold/Return or wait 16
seconds to save settings.
2: Floor Temperature Sensor Only Mode (Sens/Flr) uses the
floor sensor to regulate floor temperature only. Hold Options to
get Options menu and then press Options until Sens or Regu
appears. Then press ▼ and ▲ until Sens/Flr appears . Press Hold/
Return or wait 16 seconds to save settings.
PRODUCT SETUP AND SETTINGS
Program Day/Time Hold/Return
Options Setback Restore
Options
Options
Options
Options