Apollo CNX80 - Manual (Page 35)

Apollo CNX80 Pilot’s Guide
31
B. Add Departure Procedure (DP)
Departure procedures may be modified in either the Flight Plan (FPL)
or Procedure (PROC) modes. The Procedure mode method is shown.
1. In Flight Plan mode, highlight the flight plan name and press EXEC.
2. Press FN and then PROC.
3. In the Origin section press the Depart key.
Note
Guidance is not provided for Pilot Nav legs or Vectored DPs.
4. The runway is highlighted. Use the Small knob or Line Selection keys
on the right side of the display to select a runway.
5. Turn the Large knob to select the departure procedure and transition.
6. Verify your flight plan and resolve any discontinuities. Press Menu/
Enter.
C. Insert En Route Flight Plan Airways and/or Waypoints
1. Turn the Large knob CW to highlight the waypoint where you want to
insert a waypoint or Airway in your flight plan after it. Press → Wpt
or → Arwy. In this example, Airway is selected.
2. Turn the Small knob to select the desired point to enter the airway.
You may also press one of the Line Selection keys that display the
available airways.
3. Turn the Large knob CW one position to highlight the Intersection
choices. Turn the Small knob to choose the desired point to exit the
Airway. Press Menu/Enter.
D. Modifying a Flight Plan While In Flight
Flight plans may be modified in either the Flight Plan (FPL) or Proce-
dure (PROC) modes. In Flight Plan mode you can modify the entire
flight plan. In Procedure mode you can modify procedures for the Ori-
gin, Destination, or Alternate airports. Both methods are shown below.
Flight Plan Mode
1. Press the FN key and then the FPL key.
2. Highlight the Active flight plan and press the EDIT key.
3. If you want to change the Origin, Destination, or Alternate way-
points, press the appropriate selection key on the left side of the
display when the flight plan name is highlighted. If you want to
insert a waypoint or airway, go to step 5.
4. Turn the Large knob to highlight the leg where you want to make
the change.
Flightplan
CNX80 Pilot Guide 560-0984-00C Draft1.book Page 31 Tuesday, September 2, 2003 10:36 AM