Airstream Safari - Manual (Page 85)

G
G - 7
ELECTRICAL SYSTEM
TV ANTENNA
Manufacturer:
Winegard Company
3000 Kirkwood Street
Burlington, Iowa 52601
Phone: 800-843-4741
Raising Antenna to Operating Position
Turn elevating crank in “UP” direction until some resis-
tance to turning is noted. Antenna is now in operating
position. Check to make sure switch on front TV jack
is on.
Rotating Antenna
Make sure antenna is in “UP” position. Pull down on
directional handle with both hands until it disengages
ceiling plate and rotate for best picture and sound on
television set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional handle
aligns with pointer on ceiling plate.
WARNING : Antenna must be in “down”
position while traveling to prevent damage.
Turn elevating crank in the “Down” direction until
resistance is noted. Antenna is now locked in travel
position.
Checking Operation:
1. Tune TV receiver to nearest station and rotate an-
tenna for best picture and sound.
2. Turn off switch on power supply. Picture on TV
receiver should be considerably degraded with the
power off.
DO’S
1. Do check parking location for obstructions before
raising antenna.
2. Do carefully raise, lower and rotate - if difficult, check
for cause.
3. Do rotate slowly when selecting station and check
fine-tuning on TV set to make sure it is properly
adjusted.
4. Do lower antenna before moving vehicle.
DON’TS
1. Don’t force elevating crank up or down. Check for
cause of trouble.
2. Don’t rotate directional handle hard against stops.
3. Don’t travel with lift in up position.
4. Don’t leave lift part way up or down.
5. Don’t apply sealing compound or paint over top of
base plate or anywhere on lift.
Raising Antenna
Rotating Antenna
Lowering Antenna