LEDGlow LiteTrike III Advanced Million Color LED Lighting Kit User Manual
Page 2
the double sided tape. Note: The surface area must be free of all oils, moisture, dirt, and wax in order for the supplied
adhesive tape to bond and adhere to the installation surface correctly. Optional: To achieve the strongest bond between
the lighting strips and the trike, you can use 3M Adhesion Promoter which is included with the kit.
6.
Mount each lighting strip to the cleaned and dry surface of the trike by using the supplied 3M tape on the strip. Run the
wires to the planned location of the control box and secure each wire to the frame by using the included zip ties. Be
sure to use the zip ties, this is a very important step that should not be skipped. Once this step is complete and the
lighting strips and wires are secure, allow ample time for the adhesive to settle and cure. Repeat this step for the
remaining strips included with your kit.
7.
Now that your lighting strips are mounted and the wires are secured, you can now install the two wheel well strips. The
lighting strips must be mounted to the designated wheel well areas as each is strip features side mounting adhesion.
Install the right side wheel well strip to the right wheel well and the left side wheel well strip to the left wheel well. Run
the wires to the planned location of the control box and secure each wire to the frame by using the included zip ties. Be
sure to use the zip ties, this is a very important step that should not be skipped. Once this step is complete and the
lighting strips and wires are secure, allow ample time for the adhesive to settle and cure.
8.
Find a secure and dry place to mount the control box. We recommend mounting it under the seat or in a water tight
compartment if possible. If this is not possible then we suggest mounting the control box in the driest location
available.
9.
Connect the red power wire from the control box to the positive terminal of the battery. If the power wire needs to be
extended, be sure to use 16 or 18 gauge automotive grade wiring. Be sure to reinstall the fuse within 6 inches of the
battery. Connect the black ground wire to the negative terminal of the battery.
10. The kit was designed using a modular locking plug system for connecting the lighting strips to the control box by using
the included wire harness. Start plugging the male connections from the strips and control box into the female
connections of the harness.
11. Test the functionality of the kit once more. If everything seems to be working correctly, you can now reinstall any trim
you removed for the installation.
12. For more information, please refer to our instructional videos that can be found a
Wireless Remote Functions:
This kit provides multiple lighting patterns and several brightness levels, which are easily operated by using the
included wireless remote. The wireless remote features four buttons, “A, B, C, D”
Button A: Cycles through 15 solid colors, as well as a color cycle and color fade pattern.
Hold for 5 seconds to select brightness level when on a solid color.
Button B: Activates the strobing pattern when a single color is selected.
Hold to increase pattern speed when on a color cycle/color fade pattern.
Button C: Activates fading pattern when a single color is selected.
Hold to decrease pattern speed when on color cycle/color fade pattern.
Button D: Power On/Off
For accessories, add-on kits, replacement parts and/or Technical Support, please vi
or more information.