LEDGlow Advanced Million Color SMD LED Motorcycle Pod Lighting Kit User Manual
Page 2
zip ties. Once this step is complete and the pod lights and wires are secure, allow ample time for the adhesive to
settle and cure. Repeat this step for the remaining pod lights included with your kit.
7.
Find a secure and dry location to mount the control box. We recommend mounting it under the seat or in a water
tight compartment if possible. If this is not possible then we suggest mounting it in the driest location available.
The control box is not designed to withstand any water damage and if any does occur, it will void all
warranties. Optional: Seal the end caps of the control box with silicone to prevent water damage.
8.
Connect the red power wire from the control box to the positive terminal of the battery. Connect the black ground
wire to the negative terminal of the battery.
9.
The pod lighting kit was designed using a modular locking plug system for connecting the motorcycle pod lights
to the control box by using the included wire harness. Start plugging the male connections from the pod lights and
control box into the female connections of the harness. Secure the excess wires of the pod lights and harness to the
frame of your bike by using zip ties. DO NOT CUT OR SHORTEN ANY WIRES, YOU WILL VOID THE
WARRANTY.
10. If you removed any trim for this installation, you can now reinstall them and test the functionality of your kit by
pressing the power switch or button “D” on the wireless remote.
11. Expandability: This Pod Lighting Kit has the ability to be expanded to include up to 20 pod lights for maximum
brightness. Users can purchase Add-On Pod Lights directly from
12. For more information, please refer to our instructional videos that can be found a
Wireless Remote Functions:
This kit provides 15 solid colors, multiple lighting patterns, as well as several solid color brightness levels which are
easily selected by using the included wireless remote. The remote includes four buttons, “A, B, C, D”
Button A: Cycles through 15 solid colors as well as a color cycle and a color fade pattern.
Hold for 5 seconds to select brightness level when on a solid color.
Button B: Activates strobing pattern when a single color is selected.
Hold to increase pattern speed when on color cycle/color fade pattern.
Button C: Activates fading pattern when a single color is selected.
Hold to decrease pattern speed when on color cycle/color fade pattern.
Button D: Powers the Kit On/Off
Reprogramming the Wireless Remote:
Remove the end cap from the control box and slide the circuit board out of the housing. Remove the tape from around
the circuit board. Once the tape is removed, you will see a white box on the circuit board that says “key”. Using a paper clip,
touch the two silver tabs that are located at the bottom of the “key” box. Once you touch the two silver tabs, a red LED will
illuminate. While the LED is lit, press any button on the wireless remote and you will see the LED flash and turn off. Press the
“D” button the remote to power the kit and ensure it is functioning properly. Place the tape back on the circuit board and slide it
back into the housing of the control box.
Troubleshooting:
If the kit or lights do not appear to operate, first check the installed inline mini fuse. If the fuse is blown, check the
wires on the entire kit to ensure they are not cut, pinched or scorched. If there is no damage to any of the wires and no water
damage is visible to the control box, replace the fuse and test the kit again. If the inline fuse is intact, clean both the positive and
negative terminals of the battery. Corrosion to the battery terminal can cause a poor connection or simulate being disconnected.