LEDGlow Dual Zone - Single Color Flexible Motorcycle Light Controller - Manual

Single Color Motorcycle Lighting Kit w Dual Zone Control Box
Warning: Please check your state and local laws before installing this kit. Every state has different policies and procedures for
aftermarket accessories. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this
kit will void all warranties.
The included Motorcycle Lighting Control Box must be installed in a dry location. Having the control box exposed to
water or the elements will cause it to fail. Any water damage or corrosion to this part will VOID all warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS KIT.
Motorcycle Kit Includes:

Motorcycle LED Lighting
Strips

(1) Dual Zone Control Box

(1) Wireless Remote

Wire Harness

Zip-Ties
Motorcycle Kit Installation:
1. Upon receiving your new motorcycle lighting kit, we ask that you first test the kit to ensure it is functioning properly.
Connect the red power wire to the positive terminal of the battery and the black ground wire to the negative terminal of
the battery. Once the wires are temporarily secure, power the kit to ensure full functionality before installing it. If
everything appears to be working correctly, turn the kit off and disconnect the power and ground wires from the battery
to prepare for installation.
2. Optional: Remove any trim pieces from your motorcycle that may hinder the installation of the lighting strips.
3. Begin by first laying out the LED lighting strips similar to the way they will be installed. Make sure that the wires will
be able to be routed in such a way that they will not be pinched, cut or exposed to heat. Also, keep the wires and strips
away from all moving parts that may come in contact with any part of the kit. IF A POWER WIRE IS PINCHED, IT
WILL CAUSE THE KIT TO MALFUNCTION AND WILL VOID THE WARRANTY DUE TO PHYSICAL
DAMAGE.
4. Temporarily place the motorcycle lighting strips to their intended mounting locations and route the power wires to the
planned control box mounting area. Use the supplied zip ties to secure the power wires to their mounting points. Be
sure to keep the power wires away from the suspension, any direct heat sources and/or moving parts. A few
recommended locations on your motorcycle to mount the light strips are under the gas tank, lower frame rail, rear
fender frame rail, triple trees, lower swing arm, and under the seat.
5. Once the motorcycle lighting strips and wires have been mocked up, clean the proposed mounting surfaces with an
alcohol prep pad. The mounting surface should be between 45 and 85 degrees Fahrenheit to achieve the strongest
bonding results from the double sided adhesive tape. Note: The surface area must be free of all oils, moisture, dirt, and
wax in order for the supplied adhesive tape to bond and adhere to the installation surface correctly. Recommended: To
achieve the strongest bond between the lighting strips and the motorcycle, you can use 3M Adhesive Promoter, which
is sold separately from your kit.
6. Mount each lighting strip to the cleaned and dry surface of the motorcycle by using the supplied 3M tape. Run the
wires to the planned location of the control box and secure the wire to the bike frame by using the included zip ties. Be
sure to use the zip ties, this is a very important step and should be not skipped. Once this step is complete and the
lighting strips and wires are secure, allow ample time for the adhesive to settle and cure. Repeat this step for the
remaining strips included with your kit.
7. Find a secure and dry place to mount the dual zone control box. We recommend mounting it under the seat or in a
water tight compartment if possible. If this is not possible then we suggest mounting the control box in the driest place
available. The control box is not designed to withstand any water damage and if any does occur, it will void all
warranties. Optional: Seal the end caps of the control box with silicone to prevent water damage.