LEDGlow Dual Zone - Single Color Flexible Motorcycle Light Controller User Manual
Page 2
8.
Connect the red power wire from the dual zone control box to the positive terminal of the battery. If the power wire
needs to be extended, be sure to use 16 or 18 gauge automotive grade wire. Be sure to reinstall the fuse within 6 inches
of the battery. Connect the black ground wire to the negative terminal of the battery.
9.
This dual zone control box features two lead wires coming from the control box. These lead wires allow you to connect
two separate wire harnesses for each zone of your bike. We recommend running the LED strips that are mounted to the
front of your bike to one harness and running the LED strips that are mounted to the back of your bike to the other
harness. This dual zone control box allows for full customization so you can illuminate your bike anyway you would
like such as one color to one zone and another color to the other zone.
10. The kit was designed using a modular locking plug system for connecting the motorcycle lighting strips to the control
box by using the included wire harness. Start plugging the male connections from the strips and control box into the
female connections of the harness. Secure the excess wires of the strips and harness to the frame of your bike using the
included zip ties. DO NOT CUT OR SHORTEN ANY WIRES, YOU WILL VOID THE WARRANTY.
11. If you removed any trim for this installation, you can now reinstall them and test the functionality of your kit by
pressing the on/off button on the wireless remote.
12. For more information, please refer to our instructional videos that can be found a
4 Button Wireless Remote Functions:
This motorcycle lighting kit includes 18 different dual zone lighting modes and patterns, all of which are easily cycled
through with the wireless remote.
Button A:
1.
Channel A- Illuminated, Channel B- Off
(Hold Button A- Dims Channel A from Levels
0-100)
2.
Channel A- Off, Channel B- Illuminated
(Hold Button A- Dims Channel B from Levels
0-100)
3.
Channel A & B- Illuminated at Same Time
(Hold Button A- Dims Both Channel A & B
from Levels 0-100)
4.
Channel A- Solid On, Channel B- Fading
5.
Channel A- Fading, Channel B- Solid On
6.
Channel A- Flashing, Channel B- Solid On
7.
Channel A- Solid On, Channel B- Flashing
Button B:
1.
Channel A- Flashing
2.
Channel B- Flashing
3.
Channel A & B- Simultaneous Flashing
4.
Channel A Flashes 3 Times then Channel B
Flashes 3 Times
5.
Alternates Flashing Channel A to Channel B
Button C:
1.
Channel A- Fading
2.
Channel B- Fading
3.
Channel A & B- Simultaneous Fading
4.
Channel A- Fading, Channel B- Fading
5.
Channel A- Fading, Channel B- Flashing
6.
Channel A- Flashing, Channel B- Fading
Button D:
1.
Turns Kit On/Off
Troubleshooting:
If the kit or lights do not appear to operate, first check the installed inline mini fuse. If the fuse is blown, check the
wires on the entire kit to ensure they are not cut, pinched or scorched. If there is no damage to any of the wires and no
water damage is visible to the control box, replace the fuse and test the kit again. If the inline fuse is intact, clean both
the positive and negative terminals of the battery. Corrosion to the battery terminal can cause a poor connection or
simulate being disconnected.
For accessories, add-on kits, replacement parts and/or technical support, please v
for more information.