LevelOne WCS-2010 - Manual (Page 47)

41
Application Setup
Weekly Schedule
“Sun” ~ “Sat” Select the days of the week to perform the following operations.
“Snapshots begin at” Set the time to start operations. “Snapshots stop at” Set the time to
stop operations.
Setting identical begin time and stop time means 24-hour operation.
Event Operation
“Delay second(s) before detecting next event” Set the time delay before restarting to
check on the triggering condition when the current condition is triggered.
“Take snapshots at second(s) after event” After the camera has taken a snapshot when
a condition is triggered, another snapshot will be taken after this configured interval, in
seconds.
“Trigger condition” There are four conditions relative to the digital input and the three
windows for motion detection. More than one condition can be selected at once. Select the
appropriate digital input condition that suits the characteristics of the external device. “high”,
“low” selects level-triggering via external voltage input. “rising”, “falling” is for
edge-triggering. There are three windows for motion detection each can be assigned a
name. If motion detection has not been set up, “undefined” will be shown instead of the
window title. If this happens, clicking on “Motion detection” and a note will show to direct
the User to the configuration page for motion detection.
“Trigger action” There are four options for two types of action. More than one condition
can be selected at once. While choosing to trigger an output alarm, the digital output will
short both pins and complete the external device’s circuit. The normal state is open.
Either email or FTP can be used to command uploading snapshots. The snapshot names
will be “vpre.jpg”, “vtrg.jpg”, and “vpos.jpg”, respectively. They stand for the snapshots,
before event, right upon event, and after event. The date and time suffix may also be added
as an option. Confirm the external mail or FTP server settings in the network configuration.
“Reset output” Select and save this option to reset the external device at the digital output
to return to the original state.