LevelOne KVM-0811 - Manual (Page 14)

11
Reset Button
Push and release the reset button can reset KVM switch. This reset action will allow KVM
switch to redetect connecting PC.
If you add a new KVM Switch as a slave bank, please use reset button of master KVM
Switch to automatically assign a new ID to it. You can view this new slave bank go through
OSD menu. The PC ports of KVM Switch do not be reset by reset command.
Keyboard Hot Key Commands
You can also conveniently command KVM switch by switching ports through simple key
sequences. To send commands to KVM switch, the “SCROLL LOCK” key must be pressed
twice within 2 seconds. You will hear a beep for confirmation and the keyboard is in hot key
mode. If you have not pressed any key in hot key mode within 2 seconds (It means to key in
any key follows up “Scroll Lock” “Scroll Lock” key ), the keyboard will back to under
Operation System control state.
Below are the different hot key commands:
within 2 seconds
+ + = Previous Channel
+ + = Next Channel
Note:
You also could press “up arrow key” or “down arrow key” longer time to speed up selecting
the destination port)
Scroll
Lock Scroll
Lock
↑
Scroll
Lock Scroll
Lock
↓