LevelOne VOI-7011 - Manual (Page 15)

9
2.4. Installation
1. Connect IP Phone RJ45 WAN port to NAT Router using a
Category 5 LAN cable.
2. Connect IP Phone RJ45 LAN port to Notebook PC using
a Category 5 LAN cable.
3. Connect DC power adaptor, and the LCD panel will start
showing Loading Program! and System Initialized.
4. The LCD panel will show Date, Time and No service
without SIP registration, or <phone number> after
successful SIP registration.
5. Pick up the phone, and the LCD panel will show IP
Dialling.., and you should hear a dial tone. Please hang
up. If not, please check if the RJ45 WAN port is
connected.
6. Press MENU / 4.Network / 2.Status from the keypad to
check the IP address for IP Phone. The MENU key is
used for escape, and the ENTER key for selection. The
default IP address is 192.168.123.1. You need this IP
address for Web configurations in Chapter 7.
7. Please refer to VoIP applications examples of SIP
registrations, and register IP Phone into your SIP server.
8. The LCD panel will show Date, Time and registered
<phone number> after successful SIP registration.
9. Press the Hand-Free key, and you should hear a dial tone.
Press 123456# to call the party with the number 123456