Steelcraft Automotive 52150 GRILL GUARD - Manual (Page 2)

Page 2 of 4 6/15/09 Rev3(DP)
4. Secure the passenger side Top Support Bracket to the Top Mounting Bracket with the included (1)
10mm x 35mm Hex Bolt, (2) 10mm x 20mm OD Flat Washers and (1) 10mm Nylon Lock Nut.
Insert (1) 12mm x 35mm Hex Bolt. (2) 12mm Flat Washers and (1) 12mm Nylon Lock Nut through
the slotted hole on the side of the Top Bracket, (Figure 6). Snug but do not tighten hardware at
this time.
5. Repeat Steps 2-4 for the driver side Mounting Bracket installation.
6. With assistance, lift the Grille Guard up to the vehicle and line up the holes in the Frame Mounting
Brackets with the holes in the uprights on the Grille Guard. Insert (4) 12-1.75mm x 35mm Hex
Head Bolts, (8) 12mm x 24mm OD x 2.5mm Flat Washers and (4)12mm Nylon Lock Nuts, (Figure
6). Use (2) 8mm x 20mm Button Head Allen Bolts, (4) 8mm Flat Washers and (2) 8mm Nylon
Lock Nuts to fasten the Top Bracket to the Grille Guard, (Figure 7). IMPORTANT: Slowly close
the hood to check for clearance and fit of the Grille Guard and brackets. Adjust the Brackets as
necessary then snug but do not tighten all of the hardware. NOTE: Due to factory build variances
in vehicles, it may be necessary to adjust the height of the front bumper to provide additional
clearance for the Grille Guard Top Brackets. Loosen the bumper mounting hardware and adjust
as necessary.
7. Stand back from the vehicle and check to see that the Grille Guard is centered and level on the
vehicle and adjust as necessary. IMPORTANT: Once properly aligned, tighten all of the hardware.
8. Do periodic inspections of the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Grille Guard.
For gloss black finishes: Mild soap may be used to clean the Grille Guard.
Passenger Side Installation Pictured
Fig 2
(Fig 1) Factory tow hook location
(passenger side pictured)