Steelcraft Automotive 52150 GRILL GUARD - Manual (Page 3)

Page 3 of 4 6/15/09 Rev3(DP)
Passenger Side Installation Pictured
Use the factory 8mm hex bolts to attach the
Top Mounting Bracket to the bottom of the
crossmember. Loosen the (2) factory bolts and
slide the Mounting Bracket under the bolts.
Push the Mounting Bracket back against the
crossmember and tighten the bolts
IMPORTANT:
If installing Grille Guard without tow hooks:
Use the factory hex bolts with the supplied
10mm x 30mm OD x 2.5mm Flat Washers.
Reuse the factory flat washers on the back
of the factory mounting flange with the
included 10mm Nylon Lock Nuts.
If re-installing the tow hooks, (Fig 8), use
the supplied:
10mm x 45mm Hex Bolts
10mm Flat Washers
10mm Nylon Lock Nuts
Fig 3
(Fig 4A) Passenger side mounting location (Fig 4B) Driver side mounting location
Fig 5B
Frame Mounting Bracket
(pictured with Grille Guard in
position for example only)
Fig 5A