Steelcraft Automotive 55100 GRILL GUARD - Manual (Page 2)

(1) 10mm x
30mm Bolt, (2)
10mm Washers,
& (1) 10mm
Nylock Nut
(1) 10mm x 40mm Bolt,
(1) 10mm Washers, &
(1) 10mm Nut Plate
Passenger Side Shown
(1) 8mm x 25mm
Hex Bolt,
(2) 8mm
Washers, &
(1) 8mm Nylock
Nut
(1) 10mm x
25mm Allen
Bolt, (1) 10mm
Washers, & (1)
10mm Nylock
Nut
Passenger Side Shown
Figure 1
Figure 2
13. Align hole on the passenger side Top Bracket with hole on the Grille Guard plate. Attach Top Bracket to
Grille Guard plate with the included (1) 10-1.50mm x 25mm Allen Bolt, (1) 10mm Flat Washer, and (1)
10mm Lock Nut. Repeat this step for driver side. Do not tighten hardware at this time.
14. Level and adjust Grille Guard then tighten all hardware at this time.
15. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Page 1 of 2
2/22/07 (AM)
Cut about
1 ¾” x 1 ¾”
Cut a slot
about
3 ½” x 1”
(2) 12mm x
30mm Bolt, (4)
12mm Washers,
& (2) 12mm
Nylock Nut
Do not install fasteners on these
locations when re-installing, this
will be the inner mounting location
on the bracket
Top Support Mounting Location
Insert Nut Plate
trough here