Steelcraft Automotive 70140 BULL BAR - Manual (Page 2)

3” BULL BAR
2011 CHEVY SILVERADO/GMC SIERRA 2500/3500
Page 2 of 3 10/28/10 (DP)
Figure 1
Lock Washers and (4) 10mm Flat Washers, (Figure 5). NOTE: Do not tighten hardware at this
time.
8. Level and adjust the Bull Bar and tighten all hardware. NOTE: It may be necessary to remove
the Bull Bar to readjust the width of the Brackets on the Bull Bar and to tighten the 8mm
hardware securing the Brackets to the Bull Bar.
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Driver Side Installation Pictured
(2) 12mm x 35mm Hex Bolts
(2) 12mm Lock Washers
(4) 12mm Flat Washers
(2) 12mm Hex Nuts
Remove the factory tow
hook and hardware. Tow
hook will not be reinstalled
Front
Front
Fig 1
Fig 2