Steelcraft Automotive 70380 SPORT BAR - Manual

PARTS LIST:
1 Sport Bar 6 12-1.75mm x 30mm Hex Head Bolts
1 Driver/Left Mounting Bracket 6 12mm Nylock Nuts
1 Passenger/Right Mounting Bracket 12 12mm ID x 29mm OD x 3mm Flat Washers
2 3/8” x 1” Self Tapping Bolts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING REQUIRED
2. Measure from the driver outer edge of the air dam 23” towards the inside of the car and mark the location.
Use a hack saw to cut a 1” x 3 ½” gap on the air dam (Figure 1). NOTE: Use the mark as center of the
cutting location.
3. Remove the driver side factory hex nut located on the cross member bar. This is the hex nut that mounts the
radiator support (Figure 2).
4. Locate the driver side motor mount bushing. Use a 15mm socket to remove the two front (small) bolts.
Proceed to loosen up the rear (large) bolt just enough so you can slide the Mounting Bracket in between
motor mount support and frame (Figure 2).
5. Slide the slotted opening on the Mounting Bracket around the radiator support bolt and between radiator
bracket and frame, while you slide the Mounting Bracket between motor mount bushing (Figure 3).
6. Once the Mounting Bracket is in place, use the included 3/8” x 1” Self Tapping Bolt to attach the outer front
facing Mounting Location on the Bracket to the factory hole on the cross member bar. Re-install the factory
hex nut and the two bolts removed from the motor mount bushing. Tighten all hardware at this time including
the large bolt on the motor mount bushing and frame (figure 4). Tighten large motor mount bolt to 75 ft lbs.
7. Repeat steps 2 – 6 for passenger side Mounting Bracket.
8. With help position the Sport Bar on the outer side of Mounting Brackets. Attach Sport Bar to Mounting
Brackets using the included (6) 12mm x 30mm Hex Head Bolts, (6) 12mm Nylock Nuts, and (12) 12mm Flat
Washers (Figure 5).
Page 1 of 3
8/9/07 (AM)
INSTALLATION INSTRUCTIONS
SPORT BAR
08 GMC ACADIA
PART NUMBER