Steelcraft Automotive 155090 RUNNING BOARD - Manual

VIEWPOINT RUNNING BOARDS
2007-13 HONDA CRV
Page 1 of 7 9/14/12 (DP)
Front Front
PARTS LIST:
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED.
2. Identify and separate the driver and passenger side front and rear Mounting Brackets. Start installation
on the driver/left side of the vehicle.
3. Cut out the paper template on Page 6 labeled "Driver Side," (Figure 1). Cut out the square section on
the bottom of the Template and the (2) 8mm holes on the top. Fold the top of the Template up along the
dotted line, (Figure 2). Hold the Template in place over the outer (2) factory 8mm threaded holes next
to the pinch weld, (Figures 3 & 4). IMPORTANT: There are (4) threaded holes at each mounting
location, (2) inner on bottom of frame channel and (2) outer next to pinch weld, (Figure 5). Hold the
correct Template over the outer threaded holes and up against the plastic cover, (Figure 4). Use a
marker to trace the cut out section on the bottom of the Template onto the plastic cover. Repeat this
Step to mark the rear bracket location for cutting.
4. Remove the plastic cover. Cut out the (2) sections as marked. VERY IMPORTANT: The Templates are
driver and passenger side specific and have been provided for reference use only. It is the installer's
responsibility to be absolutely sure that the correct location has been marked before cutting the plastic
cover. To verify the locations before cutting, temporarily assemble the Mounting Brackets as pictured
on Page 1 and check the locations on the cover.
1 Driver/Left Running Board 2 10mm Lock Washers
1 Passenger/Right Running Board 20 8mm x 25mm Hex Bolts
2 Front Mounting Bracket Arms 28 8mm x 22mm OD x 2mm Flat Washers
2 Rear Mounting Bracket Arms 20 8mm Lock Washers
4 Outer Support Brackets 8 8mm Hex Nuts
1 Driver/Left Rear Inner Support Bracket 8 6mm “T” bolts
1 Passenger/Right Rear Inner Support Bracket 8 6mm x 22mm OD x 2mm Flat Washers
2 10mm x 20mm Hex Bolts 8 6mm Lock Washers
2 10mm x 20mm OD x 2mm Flat Washers 8 6mm Hex Nuts
Driver/Left
R
ear Inner Support
Bracket
(2) Front Bracket Arms
Passenger/Right Rear
Inner Support Bracket
Rear Bracket Arm
Rear Bracket Arm
Outer Support
Brackets
Outer Support
Brackets
Driver/Left
Running Board
Passenger/Right
Running Board
Front
Driver/Left Side
Passenger/Right
Side