Steelcraft Automotive 211500 3 ROUND SIDE BAR - Manual

SIDEBAR
99-11 FORD RANGER REG CAB & SUPER CAB 2 DR
Page 1 of 3 6/2/11 Rev1(DP)
PARTS LIST:
1 Driver/Left Sidebar 1 Driver/Left Side 10-1.50mm Double Nut Plate
1 Passenger/Right Sidebar 1 Passenger/Right Side 10-1.50mm Double Nut Plate
1 Driver/Left Side Front Mounting Bracket 10 10-1.50mm x 30mm Hex Bolts
1 Passenger/Right Side Front Mounting Bracket 10 10mm Lock Washers
1 Driver/Left Side Front Support Bracket 16 10mm x 20mm OD x 2mm Flat Washers
1 Passenger/Right Side Front Support Bracket 6 10mm Hex Nuts
1 Driver/Left Side Rear Mounting Bracket 4 1/2” x 2” Hex Bolts
1 Passenger/Right Side Rear Mounting Bracket 4 1/2” Lock Washers
4 1/2” x 1-1/2” OD x 1/8” Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. From under the passenger side of the vehicle, locate the three factory holes (one large, two small) in
the frame channel next to the front body mount. Insert the smaller end of the passenger side Double
Nut Plate through the large hole in the frame and line it up with the smaller hole toward the front,
(Figure 1).
3. Hang the passenger side front Bracket from the Double Nut Plate with the included (2) 10mm x 30mm
Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Figure 2).
4. Locate the factory hole on the edge of the floor panel behind the passenger front body mount. Select
the passenger side Front Support Bracket. Bolt the flat end of the Support Bracket to the factory hole
using the included (1) 10mm x 30mm Hex Bolt, (1) 10mm Lock Washer, (2) 10mm Flat Washers and
(1) 10mm Hex Nut, (Figure 3). Line up the bent end of the Support Bracket with the back of the front
Bracket. Leave Support Bracket hardware loose at this time.
5. Next, move towards the rear of the vehicle. Insert the passenger side rear Bracket up and between the
inner side panel and the outer body of the vehicle, (Figure 4 & 5)
. Line up the hole in the 90˚ bend with
the factory hole in the cab toward the bed and secure it using the included (1) 10mm x 30mm Hex Bolt,
(1) 10mm Lock Washer, (2) 10mm Flat Washers and (1) 10mm Hex Nut. Attach the upper mounting
location in the Rear Bracket to factory hole in the inner side panel using the included (1) 10mm x 30mm
Hex Bolt, (1) 10mm Lock Washer, (2) 10mm Flat Washers and (1) 10mm Hex Nut, (Figure 4 & 5). Do
not tighten hardware at this time. NOTE: On some models, it may be necessary to drill a hole through
Driver/Left Side
Front Bracket Passenger/Right
Side Front Bracket
Passenger/Right Side
Rear Bracket Driver/Left Side
Rear Bracket
Driver/Left Side Front
Support Bracket
Passenger/Right Side
Front Support Bracket
Driver/Left Side
Double Nut Plate Passenger/Right Side
Double Nut Plate