Steelcraft Automotive 211500 3 ROUND SIDE BAR - Manual (Page 2)

SIDEBAR
99-11 FORD RANGER REG CAB & SUPER CAB 2 DR
Page 2 of 3 6/2/11 Rev1(DP)
the side panel for the hex bolts. IMPORTANT: Any cutting or drilling tool may break or shatter.
Government regulations require safety glasses & equipment at all times when cutting or drilling.
6. Hold the passenger Sidebar up to the front Bracket. Insert (1) 1/2
” x 2” Hex Bolt, (1) 1/2” Lock Washer,
and (1) 1/2 ” Flat Washer through the Support Bracket, the Frame Bracket and into the Sidebar, (Figure
6). Do not tighten at this time. NOTE: To correctly identify the front of the Sidebar, note that the front
mounting leg on the Sidebar is 3/4
” longer than the rear mounting leg.
7. Once the front end of the Sidebar is loosely installed, attach the rear leg of the Sidebar to the rear
Mounting Bracket using the included (1) 1/2 ” x 2” Hex Bolt, (1) 1/2” Lock Washer and (1) 1/2” Flat
Washer, (Figure 7). Do not tighten hardware at this time.
8. Level and adjust the Sidebar and tighten all hardware.
9. Repeat steps 2-8 for driver Sidebar installation.
10. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Passenger Sidebar Installation Pictured
Double Nut Plate
(2) 10mm x 30mm Hex Bolts
(2) 10mm Lock Washers
(2) 10mm Flat Washers
Line up Nut Plate
with this hole
10mm x 30mm Hex Bolt
10mm Lock Washer
(2) 10mm Flat Washers
10mm Hex Nut
Fig 1
Front
Fig 2
Fig 3
Front
Front