Steelcraft Automotive 103800 RUNNING BOARD User Manual
Steelcraft Automotive For the car
VIEWPOINT RUNNING BOARD
07-13 CHEVY TRAVERSE/GMC ACADIA/07-10 SATURN OUTLOOK/07-09 BUICK ENCLAVE
(EXCL. ACADIA DENALI, 2010-13 BUICK ENCLAVE)
Page 1 of 5
3/5/13 (DP)
PARTS LIST:
Qty Description
Qty
Description
1
Driver/Left Running Board
8
10mm Lock Washers
1
Passenger/Right Running Board
4
10-1.5mm Hex Nuts
2
Driver/Left Mounting Brackets (front & rear same)
4
8-1.25mm x 30mm Hex Bolts
2
Passenger/Right Mounting Brackets (front & rear same)
4
8mm x 22mm OD x 2mm Flat Washers
2
Center Mounting Brackets (driver & pass same)
4
8mm Lock Washers
2
10-1.50mm Double Nut Plates
12
6-1.0mm x 20mm T-Bolts
4
10mm x 35mm L-Bolt/8mm Nut Plates
12
6mm x 22mm OD x 2mm Flat Washers
4
10mm Plastic Retainers
12
6mm Lock Washers
4
10-1.50mm x 35mm Hex Bolts
12
6-1.0mm Hex Nuts
8
10mm x 27mm OD x 3mm Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Start installation on the driver side. Locate the factory holes in the bottom and inside of the floor panel
towards the front tire opening, (Figure 1). IMPORTANT: On some vehicles, the body panel may be
filled with expanding foam insulation. Use a long flat blade screwdriver or heavy wire, (coat hanger for
example), to dig out the foam to provide clearance for the L-Bolt/Nut Plates, (Figure 2).
3. Select (1) 10mm L-Bolt/Nut Plate, (Figure 3A). Insert the bent end with the 8mm nut into the hole in the
bottom of the floor panel, (Figure 3B). Line up the hex nut with the hole in the side of the floor panel.
Thread (1) 10mm Plastic Retainer onto the 10mm Bolt end of the Bolt/Nut Plate, (Figure 3B). NOTE:
The Plastic Retainer is provided to help hold the Bolt/Nut Plate in position during Bracket installation.
(2) Driver/Left Side
Mounting Brackets
(use front or rear)
(2) Passenger/Right Side
Mounting Brackets (use
front or rear)
(2) Center Mounting
Brackets (use for driver
or passenger side)
(2) 12mm Double Nut Plates
Passenger/Right Running Board
Driver/Left Running Board
Front
(4) 10mm x 35mm Bolt/8mm Nut Plates