Steelcraft Automotive 103800 RUNNING BOARD - Manual (Page 4)

VIEWPOINT RUNNING BOARD
07-13 CHEVY TRAVERSE/GMC ACADIA/07-10 SATURN OUTLOOK/07-09 BUICK ENCLAVE
(EXCL. ACADIA DENALI, 2010-13 BUICK ENCLAVE)
Page 4 of 5 3/5/13 (DP)
Driver Side Installation Pictured
Fig 8
Rear
Rear
Use these (2) holes. Remove
foam as necessary. Insert
10mm Bolt/8mm Nut Plate
Fig 6A
(Fig 7) Driver side center mounting location
Note offset holes
(Fig 9) Driver side rear mounting location
(2) 10mm x 35mm Hex Bolts
(2) 10mm Lock Washers
(2) 10mm Flat Washers
Line up offset hole in Nut
Plate with single small hole
Fig 6B Front