Steelcraft Automotive 240710 3 ROUND SIDE BAR - Manual

3” SIDEBAR
04-12 NISSAN TITAN KING CAB
Page 1 of 3 03/26/12 Rev 2 (DP)
PARTS LIST:
1 Driver/Left Sidebar 12 8-1.25mm x 25mm Hex Bolts
1 Passenger/Right Sidebar 18 8mm Lock Washers
3 Driver/Left Mounting Brackets 18 8mm x 24mm OD x 2mm STD Flat Washers
3 Passenger/Right Mounting Brackets 6 8mm x 16mm OD x 1.6mm Small Flat Washers
6 8-1.25mm x 30mm Hex Bolts 6 8mm Nylon Lock Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Start installation at the front of the driver side of the vehicle and locate the factory threaded
stud and the threaded hole located on the side of the inner body panel, (Figure 1). NOTE:
Remove the plastic plug or any insulation on the side panel to locate the threaded holes.
3. Select (1) driver side Mounting Bracket. Attach the Bracket to the threaded stud with (1) 8mm x
24mm STD Flat Washer and (1) 8mm Nylon Lock Nut. Next, insert (1) 8mm x 30mm Hex Bolt
with (1) 8mm Lock Washer and (1) 8mm x 16mm Small Flat Washer through the remaining
lower hole in the Bracket and into the threaded hole, (Figure 2). Snug but do not tighten
hardware at this time.
Driver/Left Side
Mounting Brackets Passenger/Right Side
Mounting Brackets
Front of
Vehicle
Front of
Vehicle
Driver Side
Passenger Side
Insert locations
for brackets
Front of
Vehicle