Steelcraft Automotive 240710 3 ROUND SIDE BAR - Manual (Page 2)

3” SIDEBAR
04-12 NISSAN TITAN KING CAB
Page 2 of 3 03/26/12 Rev 2 (DP)
4. Repeat Steps 2 – 3 to install the center and rear Mounting Brackets, (Figures 2 – 4). NOTE:
The cradles on the Mounting Brackets should be facing the rear of the vehicle when properly
installed.
5. Once all three Mounting Brackets are partially installed, carefully place the driver Sidebar onto
the Mounting Brackets. Use the included (6) 8mmx 25mm Hex Bolts, (6) 8mm Lock Washers
and (6) 8mm x 24mm STD Flat Washers to bolt the Sidebar to Mounting Brackets, (Figures 3
& 4).
6. Level and adjust the Sidebar and tighten all hardware at this time.
7. Repeat Steps 2
– 6 for passenger Sidebar installation.
8. Do periodic inspections of the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver Side Installation Pictured
8mm Nylon Lock Nut
8mm x 24mm STD
Flat Washer
Front
Threaded Hole
Threaded Stud
(Fig 1) Driver side rear mounting location
pictured. Note: Remove plastic plugs to
locate factory threaded holes
8mm x 30mm Hex Bolt
8mm Lock Washer
8mm x 16mm Small Flat Washer
(Fig 2) Driver side front mounting location pictured
Front