Steelcraft Automotive 412420 4 OVAL SIDE BAR - Manual

4 ” OVAL STRAIGHT SIDEBARS
99-03, 04 HERITAGE FORD SUPER CAB F-150, F-250 LIGHT DUTY 4-DOOR
Page 1 of 3 7/16/12 Rev1(DP)
Front
PARTS LIST:
1 Driver/Left Sidebar 8 10mm Lock Washers
1 Passenger/Right Sidebar 8 10mm x 34mm OD x 3mm Flat Washers
1 Driver/Left Front Mounting Bracket (angled) 8 10mm Hex Nuts
1
Passenger/Right Front Mounting Bracket
(angled)
8 8mm x 25mm Hex Bolts
1 Driver/Left Rear Mounting Bracket (straight) 8 8mm x 24mm OD x 2mm Flat Washers
1
Passenger/Right Rear Mounting Bracket
(straight)
8 8mm Lock Washers
4 10mm x 35mm Large Double Bolt Plates 2 10mm Plastic Retainers (3-door only)
1
10mm x 35mm Small Double Bolt Plates (use
for 3-door only)
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Start installation from under the driver/left side of the vehicle. Remove the large oval rubber
cover located on the inner side panel toward the front, (Figure 1). Insert (1) Double Bolt Plate
into the oval hole, (Figure 2), and pull it back into position against the inner body panel,
(Figure 3).
3. Select the driver side front Mounting Bracket. NOTE: The Front Bracket mounting plate is
angled, (Figure 5), the mounting plate on the Rear Bracket is straight up and down, (Figure
6). Hold the Bolt Plate in place and slide the Bracket over the threaded studs, (Figure 7).
Secure the Bracket to the Bolt Plate with the included (2) 10mm Lock Washers, (2) 10mm Flat
Washers and (2) 10mm Hex Nuts, (Figure 7). Leave hardware loose at this time.
4. Repeat Steps 2 – 3 for driver side Rear Bracket installation. NOTE: A Narrow Double Bolt
Plate has been included. On 3-door models, insert the Bolt Plate into the large, round hole and
line up with the smaller round hole, (Figures 4 & 7). Use the included 10mm Plastic Retainers
to hold the Bolt Plate in position and secure the Bracket as previously described in Step 2.
5. Once the Mounting Brackets have been installed, carefully unpack and separate the Driver and
Passenger Sidebar. Attach the Sidebar to the Mounting Brackets with the included (4) 8x25mm
Driver/Left Rear
Mounting Bracket
(straight)
Large Double Bolt Plate
Small Double Bolt Plate
Driver/Left Front
Mounting Bracket
(angled)
Passenger/Right Front
Mounting Bracket (angled)
Passenger/Right
Rear Mounting
Bracket (straight)