Steelcraft Automotive 402110p 4 PREMIUM OVAL SIDE BAR - Manual

Page 1 of 3 2/23/10 Rev1 (DP)
PARTS LIST:
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. From underside of vehicle, remove the passenger side front body mount bolt, steel washer (if
equipped), and rubber bushing, (Figure 1).
3. Select the passenger side front Mounting Bracket. Insert the factory body mount bolt through
the Mounting Bracket and into the steel washer, (if equipped), and rubber bushing. Hang the
Mounting Bracket in position by partially threading the factory body mount bolt up into place,
(Figure 1). Repeat this step for passenger side Center Support Bracket, (Figure 2), and rear
Mounting Bracket, (Figure 3). Snug but do not tighten hardware at this time.
VERY IMPORTANT! There are several different designs, (depending on model year),
for the factory steel body mount bracket. The front Sidebar Mounting Brackets can be
switched, driver side to passenger side, to provide additional clearance between the
gusset on the Mounting Bracket and the factory steel body mount bracket welded to the
frame. The front Mounting Brackets however, are not interchangeable with the rear
Mounting Brackets. To prevent unnecessary noise, adjust the position of the
Mounting Brackets so that the Brackets do not come in contact with the factory
steel body mount bracket.
4. Carefully position the passenger/right Sidebar up to the Mounting Brackets. Attach the Sidebar
to the Mounting Brackets with the included (2) 1/2
” x 2” Hex Bolts, (2) 1/2” Lock Washers and
(2) 1/2 ” Flat Washers, (Figure 1 & 3). Snug but do not tighten hardware at this time.
1 Driver/Left Sidebar 4 1/2” x 2” Hex Bolts
1 Passenger/Right Sidebar 4 1/2” Lock Washers
1 Driver/Left front Mounting Bracket 4 1/2” ID x 1-1/2" OD x 1/8" Flat Washers
1 Passenger/Right front Mounting Bracket 2 10-1.50mm x 25mm Hex Bolts
1 Driver/Left rear Mounting Bracket 2 10mm Lock Washers
1 Passenger/Right rear Mounting Bracket 2 10mm ID x 20mm OD x 2mm Flat Washers
2 Center Support Brackets
INSTALLATION INSTRUCTIONS
4” OVAL SIDEBAR WITH BENT ENDS
1999-2010 SILVERADO/SIERRA EXTRA CAB 1500/2500LD
2001-2010 SILVERADO/SIERRA EXTRA CAB 2500HD-3500
(C) (C)
Driver/Left Front
Mounting Bracket
Passenger/Right
Front Mounting
Bracket
Passenger/Right Rear
Mounting Bracket Driver/Left Rear
Mounting Bracket
(2) Center Support Brackets