Steelcraft Automotive 402110p 4 PREMIUM OVAL SIDE BAR - Manual (Page 2)

Page 2 of 3 2/23/10 Rev1 (DP)
5. Line up the slot in the Center Support Bracket with the threaded insert in the Sidebar. Bolt the
Bracket to the Sidebar with (1) 10mm x 25mm Hex Bolt, (1) 10mm Lock Washer and (1) 10mm
Flat Washer, (Figure 2).
6. Level and adjust the Sidebar, check Mounting Brackets for clearance between factory steel
body mount brackets. Once satisfied with fit, tighten all hardware.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Passenger/Right Sidebar installation pictured
1/2 ” x 2” Hex Bolt
1/2” Lock Washer
1/2
” Flat Washer
Factory Bolt Factory Middle Body Mount Bolt
(Fig 1) Passenger Side Front Mounting Location (Fig 2) Passenger Side Support
Bracket Mounting Location
(Fig 3) Passenger Side Rear Mounting Location
Front
Rear
Factory Steel
Body Mount
Factory Steel
Body Mount
10mm x 25mm Hex Bolt
10mm Lock Washer
10mm Flat Washer
Complete Installation