Steelcraft Automotive 84120 REAR BUMPER GUARD - Manual (Page 2)

REAR BUMPER GUARD
05-11 NISSAN XTERRA
Page 2 of 3 6/13/11 Rev1 (DP)
2. Carefully position the Rear Bumper Guard up to the inside of the Frame Mounting Brackets.
Attach the Rear Bumper Guard to the Mounting Brackets using the included (4) 12-1.75mm x
35mm Coarse Thread Hex Bolts, (8) 12mm Flat Washers and (4) 12mm Nylon Lock Nuts,
(Figure 4).
3. Align and adjust the Rear Bumper Guard properly and tighten all mounting hardware.
4. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Rear Bumper Guard.
For gloss black finishes: Mild soap may be used to clean the Rear Bumper Guard.
Muffler/Exhaust Pipe Warning:
IMPORTANT! Due to close proximity of the Frame
Mounting Bracket to the exhaust pipe, allow exhaust
pipe to cool before starting the installation.
Fig 1
Illustration depicts typical installation on
earlier vehicles with tie down loops located
on the bottom of the frame channel
12-1.75mm x 35mm Hex Bolt
12mm Flat Washer
12-1.75mm x 35mm
Hex Bolt
12mm Flat Washer
12mm Flat Washer
12mm Nylon Lock Nut
Use Factory Hex Bolts
(2) per side (not pictured)
12-1.75mm x 35mm Hex Bolt
12mm Flat Washer
Insert through frame tie
down loops on both sides