Steelcraft Automotive 84120 REAR BUMPER GUARD - Manual (Page 3)

REAR BUMPER GUARD
05-11 NISSAN XTERRA
Page 3 of 3 6/13/11 Rev1 (DP)
Passenger Side Installation Pictured
(2) 12-1.75mm x 35mm Hex Bolts
(4) 12mm Flat Washers
(2) 12mm Nylon Lock Nuts
Fig 2
Fig 3A
(Fig 4) Driver side installation pictured
12-1.25mm x 40mm Special
Fine Thread Hex Bolt
12mm Lock Washer
(2) 12mm Flat Washers
(1 Flat Washer installed
between Bracket and frame
channel-Fig 3B)
Factory bumper
bracket bolt
Factory fine thread hole Factory hex bolt
Fig 3B
Insert (1) Flat Washer
between Bracket and
frame channel
Installation on vehicles
without tie down loops
located on the bottom of
the frame channel
Factory hex bolt
12-1.25mm x 40mm Fine Thread Hex Bolt
12mm Lock Washer
(2) 12mm Flat Washers
(1 Flat Washer installed between Bracket
and frame channel-Fig 3B)
Installation pictured on later model
vehicle without tie down loops and with
large bumper bracket reinforcement
Installation pictured on later model
vehicle without tie down loops and with
large bumper bracket reinforcement
Rear
Rear
Rear