System Sensor RTC - Manual (Page 2)

F440-02-00 2 I56-648-03
© System Sensor 1997
Three-Year Limited Warranty
System Sensor warrants its enclosed remote test coil to be free from de-
fects in materials and workmanship under normal use and service for a
period of three years from date of manufacture. System Sensor makes no
other express warranty for this remote test coil. No agent, representative,
dealer, or employee of the Company has the authority to increase or alter
the obligations or limitations of this Warranty. The Company’s obligation
of this Warranty shall be limited to the repair or replacement of any part of
the remote test coil which is found to be defective in materials or work-
manship under normal use and service during the three year period com-
mencing with the date of manufacture. After phoning System Sensor’s toll
free number 800-SENSOR2 (736-7672) for a Return Authorization number,
send defective units postage prepaid to: System Sensor, Repair Depart- ment, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please
include a note describing the malfunction and suspected cause of failure.
The Company shall not be obligated to repair or replace units which are
found to be defective because of damage, unreasonable use, modifica-
tions, or alterations occurring after the date of manufacture. In no case
shall the Company be liable for any consequential or incidental damages
for breach of this or any other Warranty, expressed or implied whatsoever,
even if the loss or damage is caused by the Company’s negligence or fault.
Some states do not allow the exclusion or limitation of incidental or conse-
quential damages, so the above limitation or exclusion may not apply to
you. This Warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
Figure 2. Ring Replacement:
TEST
COIL
4-POSITION
TERMINAL
BLOCK
1
B404B/B404BT RTS451
2
3
4
5
1
2
3
4
5
REMOTE
ANNUNCIATOR (+)
TEST COIL (+)
RTC (–)
RESET
ALARM
TEST
COIL
Figure 3. RTC Wiring Diagram:
A. Test Coil Mounting
1. Remove the decorative ring from the B404B/B404BT
base by rotating it in either direction to release the
hooks. Separate the ring from the base.
2. Position the Test Coil/Replacement Ring Assembly on
the base, as shown in Figure 2. Be sure to position the
test coil directly over the 4-Position Terminal Block.
Otherwise, the coil may not activate the switch during
a test.
3. Route the the Test Coil/Replacement Ring Assembly
wires through the slot in the base as indicated in
Figure 2.
4. Rotate the ring in either direction until it snaps in
place. Dress all wiring, as needed.
B. Wiring
1. Route four wires from the B404B/B404BT to the test
station mounting location. Be sure to comply with all
applicable electrical codes when installing this wir-
ing. This includes selecting the proper wire size and
routing through conduit, if necessary.
2. Connect the wiring to the B404B/B404BT Base and
RTS451 Test Station, as shown in Figure 3.
C. Test Station Mounting
Attach the test station to a standard 2" X 4" electrical
box, using the screws supplied with the box.
Operation
Test
Position the painted side of the test magnet on the RTS451
Test Station on either the left or right side of the LED as
shown in Figure 1. The LED should light within 40 sec-
onds, indicating that the detector being is latched in alarm.
Reset
Reset the detector by inserting a narrow bladed pocket
screwdriver, or other similar tool, into the RESET hole on
the front of the test station. Gently press until the LED
turns off.
A78-2513-00