Teka DW7 86 S - Manual (Page 10)

24
STARTING THE DISHWASHER
After carrying out all the operations described above correctly, to start
the dishwasher simply press the press the START/PAUSE button (4) for
a few seconds until a beep sounds (the PROGRAM STARTED (5) light
starts to flash). The 3-FIGURE DISPLAY (12) will show the duration of
the program in minutes. The duration time is only approximate, because
it depends on the washing conditions (quantity of dishes, water
temperature, etc.), and is also continually updated as the washing
program progresses.
The 3-FIGURE DISPLAY (12) shows the estimated duration of the
washing program.
If it is necessary to open dishwasher door during the washing cycle,
there will be a 1-minute delay before the program can be resumed.
After correctly closing the door, press the START/PAUSE (4) button
again. This operation may negatively affective the progress of the
washing cycle.
END PROGRAM
The end of the program is indicated by a short signal acoustic and from
the “End” visual notification on 3-FIGURE DISPLAY (12). By pressing
the PROGRAM SELECTION button (2), the “End” visual signal will
vanish from the display and the dishwasher is ready to continue a new
cycle, the same thing happens when closing or opening the door or by
switching on-off the machine.
REMOVING THE DISHES
At the end of the washing program, wait at least 20 minutes before
removing the dishes, to allow them to cool down. To prevent any water
droplets on the upper basket from falling on the dishes in the lower
basket, it is advisable to unload the lower basket first, and then the
upper basket.
User instructions