En en, Replacing the interior light bulb, Cleaning and care – Teka NFE2 400 User Manual

Page 13

Advertising
background image










































7

Replacing the interior
light bulb

(Fig. 9-10)

Should the light fail, switch off at the socket
outlet and pull out the mains plug.
Then ensure the bulb is screwed securely in
the bulb holder. Replace the mains plug and
switch on.
If the light still fails, obtain a replacement E14
screw-cap type 15 Watt (Max) bulb from your
local electrical store and then fit in. carefully
dispose of the burnt-out light bulb
immediately.

Cleaning and care

Interior and Exterior Surfaces


Attention

Always unplug the power cable or switch
off the circuit breaker before cleaning.

Clean the exterior using lukewarm water and
a mild detergent.

Never use detergents, abrasive or acidic
agents.

Wipe the inside compartment dry.

Be careful to prevent water from getting into
contact with the electrical connections of the
temperature control or the interior light.

If the device is not going to be used for a
long period of time, unplug the power cable
and remove all food. Clean the appliance and
keep the door open.
To preserve the appearance of your
appliance, you can polish the exterior and the
door accessories with a silicone wax.

Clean the condenser at the back of the
appliance once a year using a brush or a
vacuum cleaner. Dust build-up leads to
increased energy consumption.
Inspect the door gasket at regular intervals.
Clean with water only, and wipe totally dry.

Cleaning of the accessories

Door shelves:
Remove all food from the door shelves.
Lift the cover of the shelf upwards and pull it
off sideward.
Remove the bottom of the door shelf by
pushing it upwards.

Collecting container (Pan):
Make sure that the pan at the back of the
appliance is always clean.
Gently release the snap of the pan from the
compressor by pushing it using a tool (like
screwdriver), so that the pan can be removed.

Lift the pan, clean it and wipe it dry.
Re-assemble in reverse order.

Crisper or Drawers:
To clean a drawer, pull it out as far as
possible, tilt it upwards and then pull it out
completely (Fig. 11,12).

Odor filter:
The odor filter at the back of your fresh food
comartment prevents formation of bad smell
in your product.
To clean the odor filter remove the plastic
cover and leave the filter under sun light for a
day. Filter will be cleaned during this time
period. Fit the filter back to its place (Fig. 13)
Perform this operation once a year.

en en

Advertising