Alto-Shaam 300-HW/D443 - Manual (Page 17)

S E R V I C E
Hot Food Drop-In Well Operation & Care Manual • 15
CALIBRATION PROCEDURES
Every unit is calibrated at the factory. Only a qualified
service technician should calibrate the unit in the field
if necessary.
SHOCK RISK WARNING:
Unit must be disconnected
from power source before making adjustments or
calibrating switch.
TOOLS REQUIRED:
2mm allen (hex) wrench
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
C A U T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.
LOC P/N DESCRIPTION
1. CD-3232 CORDSET 120V (100-HW & 200-HW)
2. CD-33367 CORDSET 120V (300-, 400- & 500-HW)
3. CD-33840 CORDSET 208-240V
4. CD-3922 CORDSET 230V
5. LI-3027 WHITE POWER LIGHT 110V
6. LI-3951 WHITE POWER LIGHT 250V
7. PE-29421 PANEL OVERLAY 1-10
8. TT-34982 THERMOSTAT, 120V
9. TT-34981 THERMOSTAT, 240V
10. KN-26568 KNOB
1
2
5
6
7
8
9
3
CABLE HEATING REPLACEMENT SERVICE KITS 100-HW 200-HW 300-HW 400-HW 500-HW
KIT NUMBER 4877 4878 4880 4881 5 4880
SERVICE KIT INCLUDES:
CB-3045 CABLE HEATING ELEMENT 37 ft 67 ft 132 ft 144 ft 120 ft
CR-3226 RING CONNECTOR 2 4 8 12 8
IN-3488 INSULATION CORNER 8 ft 8 ft 8 ft 8 ft 8 ft
BU-3105 SHOULDER BUSHING 2 4 8 12 8
BU-3106 CUP BUSHING 2 4 8 12 8
SL-3063 INSULATING SLEEVE 2 4 8 12 8
TA-3540 HIGH TEMP ELECTRICAL TAPE 1 roll 1 roll 1 roll 1 roll 1 roll
ST-2439 10.32 STUD 2 4 8 12 8
NU-2215 HEX NUT 4 8 32 24 32
Part numbers and drawings are subject to change without notice .
SERVICE PARTS
4
10