Teledyne LeCroy PXA125 - Manual (Page 151)

User Manual PXA125
Programming Reference 4-33
:MARKer (?) <mark_sclk> 64e6,100e-3,100e6
:VOLTage (?) {<ampl>|MINimum|MAXimum} 5,10e-3,10
:OFFSet (?) <offs> 0,-3.6,3.6
:SINusoid
:PHASe (?) <phase> 0,0,360
:TRIangle
:PHASe (?) <phase> 0,0,360
:SQUare
:DCYCle (?) <duty_cycle> 50,1,99
:PULSe
:DELay (?) <delay> 10,0,99.9
:WIDTh (?) <pulse_width> 10,0,99.9
:TRANsition (?) <rise> 10,0,99.9
:TRAiling (?) <fall> 10,0,99.9
:RAMP
:DELay (?) <delay> 0,0,99.9
:TRANsition (?) <rise> 60,0,99.9
:TRAiling (?) <fall> 30,0,99.9
:SINC
:NCYCle (?) N_cycles> 10,4,100
:GAUSsian
:EXPonent (?) <exp> 20,10,200
:EXPonential
:EXPonent (?) <exp> -20,-100,+100
:DC (?) <%_amplitude> 100,-100,+100
APPLy:SINusoid{<freq>,<ampl>,<offs>,<phase>}
Purpose
This command is a high-level command that programs the PXA125 to output sine waveform along with its
associated parameters
•
<freq> sets the output frequency in units of hertz
•
<ampl> sets the output amplitude in units of volts
•
<offs> sets the output offset in units of volts
•
<phase> sets the output start phase in units of degrees
Parameter type
Numeric
Parameter range
<freq> 10e3 to 50e6
<ampl> 80e-3 to 8
<offs> -3.6 to +3.6
<phase> 0 to 360
APPLy:SINusoid?
Response
The PXA125 will return <freq>, <ampl>,<offs>,<phase>. Default values are
1e6,5,0,0
APPLy:TRIangle{<freq>,<ampl>,<offs>,<phase>}