Teledyne LeCroy WaveMaster 8000A - Manual (Page 36)

34
WM-GS-E Rev E
Signal Display Grid
You can set up the signal display area by touching in the toolbar. The display dialog
offers a choice of grid combinations and a means to set the grid intensity.
Trace Descriptors
Vertical and horizontal trace descriptors, or labels, are displayed below the grid. They provide a
summary of your channel, timebase, and trigger settings. To make adjustments to these settings,
touch the respective label to display the setup dialog for that function.
Channel trace labels show the vertical settings for the
trace, as well as cursor information if cursors are in use. In
the title bar of the label are also included indicators for
(SinX)/X interpolation, waveform inversion (INV), deskew
(DSQ), coupling (DC/GND), bandwidth limiting (BWL), and
averaging (AVG). These indicators have a long and short
form.
Besides channel traces, math and parameter measurement
labels are also displayed. Labels are displayed only for
traces that are turned on.
The title bar of the TimeBase label shows the trigger delay
setting. Time per division and sampling information is given
below the title bar.
The title bar of the Trigger label shows the trigger mode:
Auto, Normal, or Stopped. Below the title bar is given the
coupling (DC), trigger type (Edge), source (C1), level
(0 mV), and slope (Positive).
Shown below the TimeBase and Trigger labels is setup
information for horizontal cursors, including the time
between cursors and the frequency.