Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 136)

Chapter Three Control Reference
Sets/Queries the name of the input channel for the Y axis of the X-Y plot.
InputY Enum
Description
Values
C1
C2
C3
C4
F1
F2
F3
F4
F5
F6
F7
F8
M1
M2
M3
M4
ScanHisto
ScanOverlay
TDRN
Z1
Z2
Z3
Z4
RESULT app.Math.XY.Out.Result
Properties of the type xxxx.Out.Result.yyyy are those of the last completed acquisition. They are not affected if other
cvars are changed after that acquisition was completed. This distinction between "Out.Result" properties and other
cvars is most important when the trigger mode is Single or Stopped. You should treat "Out.Result" properties as read-
only.
Note that this XY result object is very similar, but not identical to the result object exposed by the channel and math
traces. The differences are due to the fact that the XY trace returns pairs of data values, one for X, one for Y.
For a detailed description of all properties available for the output of an XY trace, please see Chapter 1.
MEASURE app.Measure
Variables of the form app.Measure control the parameters P1 through P8, and their associated statistical results and
histicons.
916435 RevA 3-69