Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 163)

Getting Started Manual
922136-00 Rev A 155
B
C
ALIBRATION
O
UTPUT
S
IGNALS
A calibration signal can be output from the Probe Calibration Hook on the
front of the oscilloscope. The following Calibration Output Signals are
available for use:
Square Wave - You can set a Frequency value (varied based on
your specific model, refer to datasheet specifications at
teledynelecroy.com for details).
DC Level - This is a reference level.
Off - This function turns off the Auxiliary Output signal.
Date/Time
From the Date and Time tab on the Utilities dialog, you can manually set
the time and date or get it from the Internet. If you elect to get the date
and time from the Internet, you need to have the oscilloscope connected
to the Internet through the LAN connector on your instrument's I/O panel.
You can also set time zones and daylight savings time.
1. You can set the Date and Time manually by providing a value in the
Hour, Minute, Second, Day, Month, and Year using your preferred
input control method. Additional information on using the touch
screen controls can be found in the Dialog Area
(on page 42 ) . After
providing values, touch the Validate Changes button.
2. You can set the Date and Time from the Internet by first verifying
that your oscilloscope is connected to the Internet, and then
touching the Set from Internet button.
Note : The Simple Network Time Protocol (SNTP) is used.
3. You can also set the Date and Time using Windows® by touching the
Windows Date/Time button.
Windows shows a Date and Time Properties pop-up where the date
and time can be configured.