Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 44)

WaveRunner 6 Zi and 12-Bit HRO
36 922136-00 Rev A
For common oscilloscope operations, you don't need to use the top menu
bar (since you can access most dialogs from the Front Panel or from the
Descriptor Labels). However, it is the only way to access setup or other
dialogs for Display Setup, Save or Recall Waveform, Save or Recall Setups,
Print Setup, Vertical (Channel), Horizontal, or Trigger Status, Memory
(Reference Waveform) Setup, Pass/Fail Setup, or Utilities and Preferences
Setup....
The Quick Access Toolbar
The Quick Access portion of the toolbar is located on the right side of the
menu bar. It contains the Rotate Display button.
When the display is rotated, touch this button to adjust the user interface
to a portrait layout. The button toggles from portrait layout back to
landscape.
For additional information on rotating and tilting the display, refer to
Hardware and Software Controls
(on page 17 ) .
The Signal Display Grid
The grid area is divided into 8 vertical divisions and 10 horizontal divisions
just like any other oscilloscope. Set up the signal display area by touching
Display → Display Setup... from the menu bar.
The Display dialog offers a choice of grid combinations and can also set the
grid intensity.