Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 47)

29
CATC BTT RAINER 2.20 C HAPTER 4
User’s Manual Profile Wizard
Step 4
On the Select Data for Transfer screen, there are options to transfer a file or
to transfer text.
• To transfer a file: Select the radio button next to “Transfer this file.” Type
in a filename or locate the file by clicking the Browse button to access
the Open dialog. By default, the filename in the “Send data to the
following file on the receiving device” box matches the name of the file
to be transferred. If desired, enter a different filename in that box. When
the desired file and target file's name have been entered, proceed to Step 7.
• To transfer text: Select the radio button next to “Transfer this text.” Enter
text in the text box. By default, the filename in the “Send data to the
following file on the receiving device” box is “mw001.txt.” If desired,
enter a different target filename. When the desired text and target file's
name have been entered, proceed to Step 7.
Step 5
Click Next.
The Transferring File screen will appear. First, a connection with the remote
device will be established, and then data will begin transferring. A progress
bar will show what percentage of the transfer has gone through. Click Stop
Transfer to abort a transfer at any time.
When the transfer is complete, BTTrainer will disconnect from the target
device:
At this point, you can click Back to transfer another file, or click Restart to
start a new Profile Wizard session.
4.2.9 Connect to Device: PAN–GN
These steps explain how to use Profile Wizard to configure BTTrainer to connect to a
Bluetooth device that supports the Personal Area Network–Group Ad-Hoc Network profile.
Note: To connect to a device that uses the PAN profile, you must install the virtual network driver that is
included with the BTTrainer installation. For instructions, see Section 4.7, “Installation of Network
Driver,” on page 41.
Step 1
Complete steps 1-6 in Section 4.2, “Connecting to Devices” on page 21.
Step 2
Select PAN - GN from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
BTTrainer to switch roles during the connection.
Step 3
Click Next.
The Wizard will advance to the Connection Status screen. BTTrainer will
attempt to establish an ACL connection to the remote device, and then open
a BNEP connection to it. BTTrainer will then send a Setup Connection
Request Message. When BTTrainer receives the Setup Connection
Response Message from the remote device, network services may be
accessed.