Teledyne LeCroy TA700 Compliance User Guide - Manual (Page 63)

1.11
PCI BUS MASTER TIMEOUT
This test requires the IUT to be plugged on top of TA660. Therefore this test can only be done
with PCI analyzers and not CPCI. The 1.11 test will not be executed by the software when user
is using TA600C.
In this test the IUT must be plugged on the top connector of TA660. The requested transactions are
similar to the test 1.10 with the exception that each transaction has four data phases.
Compliance Test
63 Rev. 1.0