Teledyne LeCroy SAS_SATA InFusion - Users Manual - Manual (Page 23)

SAS InFusion User Manual Version 2.0
LeCroy Corporation
9
Step 4 Turn ON the power switch on the rear of the box. After power is
ON, the SAS InFusion box boots up. This initialization process
lasts a few seconds. During boot-up the box displays
initialization messages and beeps once.
If your LAN uses Dynamic Host Connection Protocol (DHCP), plugging the box into your
LAN will cause your DHCP server to allocate an IP address and subnet mask and bring
SAS InFusion up onto the network. If your LAN uses static IP addressing, you will need
to use the LCD panel to assign an IP address, subnet mask, and default gateway.
Assigning a
Static IP
Address
Using the
LCD Panel
If your network does not use DHCP, you can assign a static IP address via the LCD
panel.
Figure 4 LCD Panel Root Menu at Initial Set-up
Step 1 From the Root menu on the LCD panel, press the Select (middle) button
to go to the Box Setup menu. The Box Setup menu appears (Figure 5).
Figure 5 LCD Panel Box Setup Menu
Step 2 Press the Bottom button once on the LCD panel to move the
selection arrow next to IP Mode.
Step 3 Press the Select button to select IP Mode. The IP Mode menu
appears (Figure 6). It shows two options: Static and Dynamic.
The default selection is Dynamic.