Using captured data dwords – Teledyne LeCroy SAS_SATA InFusion - Users Manual User Manual
Page 57
SAS InFusion User Manual
Version 2.0
LeCroy Corporation
43
Using
Captured
Data
Dwords
Captured data dwords can be used in creating events for data that match the captured
dword(s), or in creating actions to substitute the captured dword(s) into the data stream.
To create an event using the captured dword, in the Event Properties menu select SAS
Data Pattern (or SATA Data Pattern), and then select any of the 12 dwords (Dword 0
Type through Dword 11 Type). The drop-down menu provides the choice of a custom
dword or any of the four captured dwords. If you select a captured dword, the Value field
beneath this selection will be hidden (the Value field is only used for specifying custom
dwords). Note that choice of a mask and an offset are still available when using captured
dwords.
Figure 39
Using a Captured Dword in a SAS Data Pattern