Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 457)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 453
Sierra Trainer Generation Language Teledyne LeCroy
SATA Speed Negotiation Settings
OOB_SpeedNeg_RCDT
750000 Maximum time in OOBIs during the speed
negotiation window for a transmitter to reply with
ALIGN(1).
OOB_SpeedNeg_SNTT 163840 Time in OOBIs during which ALIGN(0) or ALIGN(1) is
transmitted at each physical link rate during the
speed negotiation sequence.
OOB_SpeedNeg_SNLT 153600 Time in OOBIs during which the transmitter shall
transmit idle between rates during speed
negotiation.
Speed Settings
Speed
>>>>> Link Speed Possible Values: 
LINK_SPEED_1_5G LINK_SPEED_3G LINK_SPEED_6G
Default Value: LINK_SPEED_1_5G
RateMatching 0 When set, the generator will automatically inserting
the stream Align(0) primitive after every
DWORD .
Scrambling Mode Settings
Scrambling
>>>>> Raw Data Scrambling Mode ‐ Only those raw
DWORDs will be scrambled that contain only data
bytes (no 10‐bit symbols or 'K' bytes. Scrambling is
reset by changing ScramblingMode or by any valid
SAS or SATA frame.
When Scrambling is on, scrambling is done by Trainer
engine. It automatically detects scrambling type (SAS
or SATA) by start frame primitive.
When Scrambling is off, data is sent without any
scrambling.
Possible Values: 
SCRAMBLING_MODE_NONE
SCRAMBLING_MODE_SAS 
SCRAMBLING_MODE_SATA 
SCRAMBLING_MODE_AUTO
Default Value: SCRAMBLING_MODE_AUTO
Setting
Default
Value
Description