Teledyne LeCroy Small Rackmount AC012XXA-X Install Guide - Manual

You will also need the
following additional tools:
• Tape Measure
• Level
• Phillips Screwdriver
The kit includes the following components:
Quantity Part Description
2 L Brackets
1 9/64 Allen Key
4 10-32 x 0.5 Screws
(for securing the
system chassis to the
rack)
Rack Mount Kit Components
2
PN: 918446-00
08/2010 Rev A
4 x Screws 2 x L Brackets
Installing the System Chassis into the Rack
5
Follow these steps to install the system chassis in an open rack that enables you
to slide the chassis in from the front.
Step 1: Position the chassis in the rack as follows:
Step 2: Use your tape measure and level to ensure that the supporting shelf and
the chassis are installed straight and level.
Step 3: Make sure that your path to the rack is unobstructed.
Step 4: Slide the unit into the rack and position using the attached L brackets so
that the slots in the brackets are positioned over the appropriate
mounting holes in the side rails of the rack.
Step 5: Securely fasten the unit into the rack by using the four 10-32 x 0.5
screws which are supplied with the rack mount kit, installing two of the
screws on each side of the unit. Use a Phillips screwdriver to tighten the
screws.
This concludes the rack mount installation.
1 x Allen Key
A location for the system chassis should be planned taking these restrictions into
consideration.
WARNING: In order to provide stability to the rack, systems should
first be installed from the bottom, with the heaviest components
located in the bottom of the rack. If the rack is provided with
stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack.
Spacing and Airflow
Allow, at a minimum, 2-3“ of space around each side of the system, and 3-4” of
space in the rear of the system. This allows adequate airflow to cool the system.
The air temperature within the rack enclosure should not exceed 92˚F (50˚C).
Power Supply
The system requires a source of AC power (100-240V, 50-60 Hz, 230W) routed to
the rear of the system. All other controls and wiring connections are located on the
front panel of the system.
Planning the Installation (continued…)
4
Small Rackmount Accessory Kit
AC012XXA-X
Installation Guide
This manual describes the procedures to retrofit Sierra M6-2, SierraFC M8-4, and
Voyager M3i systems for rack mounting at your site.
The rack mount kit included is for securing the any of the systems mentioned above
in an EIA 310-D 19-inch equipment rack.
Two L brackets, which are attached (as shown in this document) to the front or back
of the Hamilton chassis, connect the chassis to the mounting posts of the rack.
Some racks provide a power strip along the length of one of the rear posts. If your
rack has this feature, consider the position of the strip when planning fastener
points, and before you install the L brackets on the chassis, determine whether you
will install the chassis from the front or the rear of the rack.
Introduction
1