Teledyne LeCroy CPCI64 - Manual (Page 10)

10
SPECIFICATION: CPCI-64
Bus: CompactPCI 32 or 64 bit, system slot or adapter card.
Voltages:
Input requirement +5V at 200 ma, +/- 12V at 50 mA.
Inputs for UUT From PC bus or the external input, configurable jumpers per voltage.
Output Ratings +5V, Jumper selectable to 5 Amp or 1 Amp limit.
+3.3V @ 2.5 Amps.
+VIO @ 1 Amp.
+/- 12V @ 1 Amp.
Output Voltage Drop 40 millivolts drop for every 1 Amp drawn for +5V, +3.3V and +VIO.
30 millivolts drop for every 1 Amp drawn for -12V.
30 millivolts drop for every 100 milliampere drawn for +12V.
Propagation Delay: Less than 500 pico-seconds from the PC bus to the UUT. The switch
propagation delay is rated at only 250 Pico-seconds.
ON-OFF Controls: SPST switch on-board, or JPX.
Outputs:
J3 +5V, +12V and +3.3V current draw by the UUT can be measured at
a four-point terminal, J3, by a voltmeter. Each volt represents 1
Amp.
JTA-E All CompactPCI signals.
Mechanical Dimensions:
Height 8 inches
Width 3.94 inches, 3U