Teledyne LeCroy CPCI64 - Manual (Page 9)

9
SPECIFICATION: PCIAX532 & PCIAX332
Bus: PCIAX-532, 32-bit PCI, 5V key and universal.
PCIAX-332, 32-bit PCI, 3V key and universal.
Voltages:
Input requirement +5V at 200 mA, +/- 12V at 50 mA.
Inputs From PC bus or the external input, configurable by jumpers per
voltage. (For Rev B boards only)
Output Ratings +5V, Jumper selectable to 5 Amp or 1 Amp limit, higher than 5 Amp
current limit can be accommodated per user request.
+3.3V @ 2.5 Amps if on-board regulator is used.
+3.3V @ 5 Amps if system provides 3.3 Volts.
+VIO @ 1Amp.
+/- 12V @ 1 Amp.
Drop Across the Switches 40 millivolts drop for every 1 Amp drawn for +5V, +3.3V and +VIO.
30 millivolts drop for every 1 Amp drawn for -12V.
30 millivolts drop for every 100 milliampere drawn for +12V.
Propagation Delay: Less than 500 pico-seconds from the PC bus to the UUT. The switch
propagation delay is rated at only 250 Pico-seconds.
On-Off Controls: SPST switch on-board, or the system parallel port.
Outputs:
J3 +5V, +12V and +3.3V current draw by the UUT can be measured at
a four-point terminal, J3, by a voltmeter. Each volt represents 1
Amp.
JP1 JP1-1 to JP1-59, all odd pins on the B side, 100 mil centers.
JP1 JP1-2 to JP1-60, all even pins on the B side, 100 mil centers.
JP2 JP2-1 to JP2-59, all odd pins on the A side, 100 mil centers.
JP2 JP2-2 to JP2-60, all even pins on the A side, 100 mil centers.
The signals at JP1 and JP2 are active when the extender power is on and tri-stated when the power is off.
Mechanical Dimensions:
Height 4.5 inches
Length 6.8 inches