Teledyne LeCroy QPHY-HDMI User Manual
Qphy-hdmi operator’s manual
Advertising
Table of contents
Document Outline
- Introduction
- QPHY-HDMI Testing
- Test Preparation
- QPHY-HDMI Test Configurations
- QPHY-HDMI Test Descriptions
- QPHY-HDMI Variables
- Execution Order Mode
- Demo Mode
- HDMI version tested
- Number of sweeps acquired for a measure
- User defined signal vertical gain
- User defined signal vertical offset
- Re-use vertical settings
- Save acquired waveforms
- Silent mode control
- TMDS Data Pair to test
- Use stored trace for pixel clock measure optimization
- Waveform Path
- Specific to “Test7-2: TMDS-VL” Group
- Specific to “Test7-4: TMDS TRise, TFall” Group
- Specific to “Test7-6: TMDS Inter-Pair Skew” Group
- Specific to “Test7-7: TMDS Intra-Pair Skew” Group
- Specific to “Test7-8: TMDS Clock Duty Cycle” Group
- Specific to “Test7-9: TMDS-Clock Jitter” Group
- Specific to “Test7-10: TMDS-Data Eye Diagram” Group
- QPHY-HDMI Limit Sets
- Manual Deskewing Procedures
- Error Messages