Qphy-sas2 test configurations, 5 gbps tx tests using live (acquisition) data, 5 gbps tx tests using saved data – Teledyne LeCroy QPHY-SAS2 User Manual
Page 24: 0 gbps tx tests using live (acquisition) data, 0 gbps tx tests using saved data
24
917718 Rev
A
QPHY-SAS2 TEST CONFIGURATIONS
Configurations include variable settings and limit sets as well, not just test selections. See the QPHY-SAS2
Variables section for a description of each variable value and its default value.
1.5 Gbps Tx tests using Live (Acquisition) Data
This configuration will run all of the tests except for the deskew tests and the WDP test. The limit set in use is
SAS2-1.5G. All of the variables are set to their default settings except Bitrate is set to 1.5e9.
1.5 Gbps Tx tests using Saved Data
This configuration will run all of the tests except for the deskew tests and the WDP test. The limit set in use is
SAS2-1.5G. All of the variables are set to their default settings except Bitrate is set to 1.5e9 and Test Mode is set
to Use Saved Data.
3.0 Gbps Tx tests using Live (Acquisition) Data
This configuration will run all of the tests except for the deskew tests and the WDP test. The limit set in use is
SAS2-3G. All of the variables are set to their default settings except Bitrate is set to 3e9.
3.0 Gbps Tx tests using Saved Data
This configuration will run all of the tests except for the deskew tests and the WDP test. The limit set in use is
SAS2-3G. All of the variables are set to their default settings except Bitrate is set to 3e9 and Test Mode is set to
Use Saved Data.
6.0 Gbps Tx tests using Live (Acquisition) Data
This configuration will run all of the tests except for the deskew tests and the WDP test. The limit set in use is
SAS2-6G. All of the variables are set to their default settings except Bitrate is set to 6e9.
6.0 Gbps Tx tests using Saved Data
This configuration will run all of the tests except for the deskew tests and the WDP test. The limit set in use is
SAS2-6G. All of the variables are set to their default settings except Bitrate is set to 6e9 and Test Mode is set to
Use Saved Data.
Demo of 6Gbps Tx tests using Saved Data
This configuration will run all of the tests on the demo waveforms (available from www.lecroy.com). The limit set
in use is SAS2-6G. All of the variables are set to their default settings except Bitrate is set to 6e9, Test Mode is
set to Use Saved Data, Path to saved Waveforms for offline tests is set to D:\Waveforms\SAS2\Demo and
Demo Mode is set to Yes.