Certifications – Teledyne LeCroy WaveStation 3000 Getting Started Guide User Manual

Page 10

Advertising
background image

8

922868-00 Rev A

Certifications

This section certifies the instrument’s Electromagnetic Compatibility
(EMC), Safety, and Environmental compliance.

EMC Compliance

EC DECLARATION OF CONFORMITY - EMC
The instrument meets intent of EC Directive 2004/108/EC for
Electromagnetic Compatibility. Compliance was demonstrated to the
following specifications as listed in the Official Journal of the European
Communities:

EN 61326-1:2006, EN 61326-2-1:2006 EMC requirements for electrical
equipment for measurement, control, and laboratory use.

Safety Compliance

EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The instrument meets intent of EC Directive 2006/95/EC for Product
Safety. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:

EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements

EN 61010-2:030:2010 Safety requirements for electrical equipment
for measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits

U.S. NATIONALLY RECOGNIZED AGENCY CERTIFICATION
The instrument has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears UL Listing Mark:

UL 61010-1 Third Edition, Safety standard for electrical measuring and
test equipment.

CANADIAN CERTIFICATION
The instrument has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears cUL Listing Mark:

CAN/CSA-C22.2 No. 61010-1-12 Safety requirements for electrical
equipment for measurement, control and laboratory use.

Environmental Compliance

END-OF-LIFE HANDLING

The instrument is marked with this symbol to indicate
that it complies with the applicable European Union
requirements to Directives 2002/96/EC and 2006/66/EC
on Waste Electrical and Electronic Equipment (WEEE)
and Batteries.

The instrument is subject to disposal and recycling regulations that vary
by country and region. Many countries prohibit the disposal of waste
electronic equipment in standard waste receptacles. For more information
about proper disposal and recycling of your Teledyne LeCroy product,
please visit teledynelecroy.com/recycle.

RESTRICTION OF HAZARDOUS SUBSTANCES (ROHS)
This instrument has been classified as Industrial Monitoring and Control
Equipment, and is outside the scope of the 2011/65/EU RoHS Directive
until 22 July 2017 (per Article IV, Paragraph 3).

certificatiONs

Advertising