Teledyne LeCroy WaveStation 3000 Getting Started Guide - Manual (Page 8)

6 922868-00 Rev A
Precautions
Use proper power cord. Use only the power cord shipped with this
instrument and certified for the country of use.
Maintain ground. This product is grounded through the power
cord grounding conductor. To avoid electric shock, connect only to a
grounded mating outlet.
Observe all terminal ratings. Do not apply a voltage to any input that
exceeds the maximum rating of that input. Refer to the markings next
to the BNC terminals for maximum allowed values.
Use only within operational environment listed. Do not use in wet or
explosive environment. Use indoors only.
Keep product surfaces clean and dry.
Do not block the cooling vents. Leave a minimum six-inch (15 cm)
gap between the instrument and the nearest object. Keep the underside
clear of papers and other objects.
Do not remove the covers or inside parts. Refer all maintenance to
qualified service personnel.
Do not operate with suspected failures. Check body and cables
regularly. If any part is damaged, cease operation immediately and
sequester the instrument from inadvertent use.
Power
AC Power: 100 - 240 VAC (±10%) at 50/60 Hz (±5%) or 100 - 240 VAC
(±10%) at 400 Hz (±5%)
Maximum power consumption: 50 VA
safety
Safety
Observe generally accepted safety procedures in addition to the
precautions listed here.
Operating Environment
Temperature: 0° C to 40° C
Humidity: Maximum relative humidity 80% (non-condensing) for
temperatures up to 30° C decreasing linearly to 50% relative humidity
at 40° C.
Altitude: Up to 10,000 ft (3,048 m) at or below 30° C
Symbols
These symbols appear on the body of the instrument or in
documentation.
CAUTION of potential damage to equipment, or WARNING of
potential bodily injury. Do not proceed until the accompanying
information is fully understood and conditions are met.
Measurement ground connection.
Frame or chassis connection.
Safety (protective) ground connection.
Power on/off.