Tracer TP-8100 A98253-7 - Manual (Page 2)

WARRANTY
The warranty policy for the TP-8100 lamp is provided on the Certificate of Limited Warranty enclosed separately with each unit.
NOTE: For assistance of any kind, contact the Customer Service Department at Tracer Products. In the U.S. and Canada, call toll-
free 1-800-641-1133. Give full details of the difficulty and include the model and serial numbers of the unit and the date of purchase.
If return of the unit to the factory is deemed necessary, shipping instructions will be provided. If an estimate of charges for nonwar-
ranty work or other service work is required, a quote will be furnished upon evaluation of the unit. Out-of-warranty service work will
not be performed without customer approval.
12/99 A98253-7
PRINTED IN U.S.A.
TO REPLACE THE FILTER LENS
Use only the TP-8211 filter lens.
1. Remove the rubber filter holder and discard the old filter lens.
2. Using a clean cloth, press the new filter lens into the filter holder. Make sure that the side of the lens with the dot faces t o w a r d
the bulb.
3. Reattach the filter holder.
TO REPLACE THE BULB
Use only the 35-watt TP-8110 bulb.
Using any other bulb may damage the lamp and will void the warranty.
1. Remove the filter holder, the bulb guard and the old bulb.
2. Holding the new bulb by the edge of the reflector, press it into the two-pin socket firmly but gently.
3. Reattach the bulb guard and filter holder.
Filter Holder Magnet
Rocker Switch
Bulb Guard
TP-8211
Filter Lens
TP-8110
35-Watt Bulb
Cord with Battery Clips